The ZC-BOB is a wall mounted break out box provides up to six RJ-45 input jacks for home run or parallel wiring configurations of the dbx ZC wall panel controllers and one output RJ-45 jack for connection to the dbx DriveRack or ZonePRO device. The device shall be a dbx ZC-BOB remote controller. The zone controller offer extended utility to the DriveRack and ZonePRO families. The zone controllers use analog DC voltage to provide logic control ranging from zone source selection, volume and muting, to program or scene selection and fire safety muting. Wired with readily available and affordable CAT5 cable with universally accepted RJ-45 connectors at distances up to 1000ft. The ZC zone controllers offer simple yet elegant solutions to the contractor.
Offers simple yet elegant solutions
Offers extended utility to the DriveRack and ZonePRO families
Maximum cable length varies with number of zone controllers
Use analog DC voltage to provide logic control ranging from zone source selection, volume and muting
Wired with CAT5 cable with universally accepted RJ-45 connectors at distances up to 1000ft
UL 60065, IEC 60065, EN 55013 and E60065 safety agency certifications
Spec Sheet available - Yes
Connectors:
(7) RJ-45
Series Wiring:
Maximum cable length varies with number of zone controllers (600ft for 3 zone controllers 300ft for 6 zone controllers)
Parallel Wiring using ZC-BOB:
Up to 6 zone controllers (1000ft)
Parallel Wiring Cable:
CAT5 or CAT5E with 28.6 Ohms/m (Ohm/1000ft) nominal DCR and rated VW-1 or higher